Build a circuit
Drag a battery, a resistor and an LED onto the canvas, then click pin to pin to wire them up.
Build a circuit
Drag a battery, a resistor and an LED onto the canvas, then click pin to pin to wire them up.
Code runs on a board. Place an Arduino UNO R4 in the circuit, then come back to program it.
Build with STEMFIE
Put down beams, braces and plates, then join them hole to hole. Every joint is a real screw and nut.
No 3D view
This browser could not start WebGL, which the Build tab needs.
The Arena
Where your robot drives. Build it in the Build tab, wire its motors in the circuit, then press Simulate.
No 3D view
This browser could not start WebGL, which the Arena needs.
vendor/codemirror.js did not load.
No lesson pages yet
The class's teacher adds them on the course page.